Model number SSPA 0.2-2.5-200 is a high power, decade plus bandwidth, GaN solid state power amplifier (SSPA). This amplifier continuously covers the full band of 200 to 2500 MHz. It can be commanded on and off in 10 uSecs maximum to control DC power consumption and to gate the RF drive signal. The output power is 200W typical at PSat across the band at room temperature. This GaN broadband SSPA is designed to be employed in any system where high power, high efficiency, and high linearity are required across a large frequency spectrum. Nominal input drive for full rated Pout is 0 dBm. Small signal gain is ~60 dB. The composite power added efficiency with a CW input is between 35 to 50% at room temperature with better PAE towards the lower end of the band. Input VSWR is 2.0:1 maximum. The input voltage is +50 Vdc. Standard features include reverse polarity protection, output short and open circuit protection, and over/under voltage protection. All functionality is controlled via external discrete signals applied to the DSUB. (Please consult factory regarding the SCD for specifics.) Temperature is monitored and reported by this module. This power amplifier module operates from -40 to +85ºC base plate temperature. The amplifier will need to be cooled via conduction to a heat sink. This module is designed and tested to withstand MIL-STD-810 high shock and vibration requirements. DC and logic connections are accessible via a DSUB connector. The RF input connector is SMA female. The RF output connector is Type N female.